Unlinking Steps - Lateral Linking System Klaxon - Klaxon TWIST Gebrauchsanleitung

9.5.2 UNLINKING STEPS - LATERAL LINKING SYSTEM KLAXON®
Throughout the unlinking phase, make sure to be on a flat area, as free as possible of
unevenness in the terrain and away from dangers to the safety of the person and of others.
Be careful not to squeeze or entrap your fingers during the unlinking operations. Potential
finger traps and squeezing points are shown in chapter 21.
Remove the device as described in sections 10.2 and 11.4.
Loose the clamps' lever screws (Figure 38 Letter G) until the forks (Figure 37 Letter C) can slide out easily
and without interferences (Figure 44).
Remove the Lateral Linking System kit by sliding the forks out of the clamps (Figure 38 Letter F). (Figure 45).
At this point the Lateral Linking System is disconnected both from the TWIST and the wheelchair as shown
in Figure 46. Please note that the clamping rings always remain installed on the wheelchair.
Store the Lateral Linking System kit in a safe place.
36
KLAXON Mobility GmbH - EN
KLAXON TWIST device - End User's Manual (EN) - rev. 1.5 of 2023.02.08
Figure 44
Figure 45
Figure 46