Klaxon TWIST Gebrauchsanleitung Seite 70

The wireless control must always be firmly mounted to the wheelchair (see section 9.2).
Before driving:
Make sure the TWIST is turned on by pressing the appropriate button on the battery. Two short acoustic
signal will be emitted by the TWIST.
Make sure the TWIST is installed to the wheelchair (see chapter 12).
Make sure the Controller is connected to the wheelchair.
Make sure the Controller has been turned on by pressing the appropriate button on the control. The LEDs
will light up and flash until the connection with the TWIST is made. A short acoustic signal will be emitted
to confirm the successful connection, while the LEDs of the control will remain lit without flashing.
Start and stop through use of the wheelchairs' wheels
When the TWIST is installed at the rear, the Assisted Start function is deactivated.
When the TWIST is installed at the rear, it is not able to brake the wheelchair, in particular
when driving downhill.
Start and stop through the use of the Controller
To start, push the speed selection lever forward and release it to shift into gear 1. Repeat the same operation
to increase speed. There are 4 speeds and the maximum speed is 6 km/h.
To reduce speed, press and release the speed selection lever in the opposite direction of the drive direction.
With each press and release, the speed will be reduced until it reaches the zero gear, which corresponds
to the neutral
To deactivate the motor thrust, briefly press the Controller's stop button.
To temporarily deactivate the motor thrust and then reactivate it, press and hold the button for longer than
1.5 seconds. When released, the device will restart from the speed of the first gear..
Steering
The TWIST installed at the rear can be steered by braking and pushing the wheels of the wheelchair, or
(recommended) by performing both operations simultaneously, just as when driving the wheelchair without the
TWIST installed. Please note that the power provided by the motor increases as the resistance increases (as, for
example, when driving uphill) so as to maintain the set speed constant.
An example: to turn right, brake the right wheel and push the left wheel at the same time. To turn left, brake the
left wheel and at the same time push the right wheel. It is advisable, particularly in the initial learning stages, to
reduce the speed before commencing a curve by acting on the Controller (see section 9.2) (Figure 113).
KLAXON Mobility GmbH - EN
KLAXON TWIST device - End User's Manual (EN) - rev. 1.5 of 2023.02.08
Figure 113
69