Klaxon TWIST Gebrauchsanleitung Seite 52

Place the TWIST on its kickstand and on a flat surface (Figure 78 Letter A).
Rotate the steering system by 180° so that the upper and lower pin bracket (Figure 1 Letter G) points
towards the front light (Figure 78 Letter B).
Ensure that all controls are switched off. Hold the handlebar, making sure that the two alignment arrows are
aligned with each other. Only in this position will it be possible to mount the handlebar (Figure 79).
Do not use the device with the handlebar if the arrows in Figure 79 are not aligned. In case
the arrows are not aligned, the controls are not in the expected position for driving straight.
Insert the handlebar base into the steering base (Multi-link Klaxon®) with a movement that is perpendicular
to the steering of the TWIST (Figure 80 Letter A).
Make sure that the handlebar is fully inserted and fully in contact with the steering base. (Figure 80 Letter
B).
A
Screw the knob clockwise until it is as tight as possible. Caution: do not use tools, but only the hands
(Figure 81).
Using the device with the knob in Figure 81 not securely tightened exposes to the risk that
the handlebar disengages with a consequent loss of control of the device.
KLAXON TWIST device - End User's Manual (EN) - rev. 1.5 of 2023.02.08
KLAXON Mobility GmbH - EN
B
Figure 79
Figure 80
Figure 81
51