Klaxon TWIST Gebrauchsanleitung Seite 53

Press the red button (Figure 60 Letter A) on the side of the Front Linking System 2.0 to make sure that the
hook opening is free and ready to accommodate the upper pin. If the button is locked, the system is ready
to be linked (Figure 60).
Grab the handlebar and tilt the TWIST towards the wheelchair to position the upper pin (in orange in Figure
83) inside the hook opening (Figure 82) and (Figure 84).
Lift the lever (Figure 60 Letter B) to engage the hook and secure the TWIST. Ensure that the red button
moves outwards until the green ring on the left appears. The green ring confirms the correct engagement
(Figure 84). If the green mark does not appear, repeat the operation from the start.
If the green mark does not appear when the operation is repeated, this means that the Front
Hook 2.0 Klaxon® is not properly engaged. Please contact a KLAXON service centre to carry
out a technical check.
52
KLAXON Mobility GmbH - EN
KLAXON TWIST device - End User's Manual (EN) - rev. 1.5 of 2023.02.08
Figure 82
Figure 83
Figure 84