Installation Of The Handlebar With The Twist Already Installed To The Wheelchair - Klaxon TWIST Gebrauchsanleitung

It is advisable to avoid using the device when the Handlebar Control's battery is running low
as, if its battery runs out, the TWIST will perform a safety stop and can then only be moved
by manual push (no function is active when the Controller is switched off).
When mounting the handlebar and connecting it, make sure that no other controls in the
vicinity are switched on.

11.1 INSTALLATION OF THE HANDLEBAR WITH THE TWIST ALREADY INSTALLED TO THE WHEELCHAIR

Make sure that the TWIST is correctly installed to the wheelchair and is in the correct operating position
(the wheelchair should have the front castors raised off the ground). It will not be possible to mount the
handlebar if the TWIST is not in the specified position (Figure 68).
Ensure that the TWIST has the wheel aligned with the handlebar. The wheel must not be steered to the
right or left (Figure 69).
Make sure the Handlebar Control is switched off.
Make sure that the Controller is also switched off.
Hold the handlebar, making sure that the two alignment arrows are aligned with each other. Only when this
position is reached will it be possible to mount the handlebar (Figure 70).
Do not use the device with the handlebar if the arrows in Figure 70 are not aligned. In case
the arrows are not aligned, the controls are not in the expected position for driving straight.
KLAXON Mobility GmbH - EN
KLAXON TWIST device - End User's Manual (EN) - rev. 1.5 of 2023.02.08
Figure 68
Figure 69
Figure 70
47