Installing The Controller On The Wheelchair - Klaxon TWIST Gebrauchsanleitung

Right Side Controller
If the Right Side Controller was chosen at the time of purchase, it must be installed on the right side of the
wheelchair. In order to shift gears, simply push the lever forward. Conversely, to be able to downshift gears,
simply push the lever backwards.
If the Controller is installed on the opposite side to the one for which it was designated,
the controls will operate in the opposite way (Figure 9). Always ensure correct installation
before operating.
Left side Controller
If the Left side Controller was chosen at the time of purchase, it must be installed on the left side of the
wheelchair. In order to shift gears, simply push the lever forward. Conversely, in order to downshift gears, simply
push the lever backwards.
If the Controller is installed on the opposite side to the one for which it was designated,
the controls will operate in the opposite way (Figure 10). Always ensure correct installation
before operating.

9.2.1 INSTALLING THE CONTROLLER ON THE WHEELCHAIR

If it is intended to mount the Controller on the Right, make sure that a Right Controller has
been purchased. If installing the Left Controller, make sure the Left Controller has been
purchased.
18
KLAXON Mobility GmbH - EN
4 < 3 < 2 < 1
th rd nd st
KLAXON TWIST device - End User's Manual (EN) - rev. 1.5 of 2023.02.08
1 st > 2 nd > 3 rd > 4 th
Figure 9
Figure 10