Installing The Controller With Velcro Attachment System - Klaxon TWIST Gebrauchsanleitung

For the standard Quokka® system attachment please refer to this subsection and to the
NOTE manual of the product provided with the attachement. For the instructions related to the
Velcro attachement please refer to this subsection and to subsection 9.2.2.
Locate the most convenient, accessible mounting position where the Controller can be installed (Figure 11).
It is recommended to mount the Controller in such a way that it does not interfere with or
prevent the use of the wheelchair brakes.
When mounting and/or operating any accessories or components on the wheelchair, ensure
that they do not interfere with or impair the use of the Controller.
Mount the Controller in such a way that no controls, levers and/or buttons can be operated
unintentionally (including those on the wheelchair and all the accessories).
Once the position has been found, screw the adjustment ring (for Velcro or Quokka®) to the Controller using
the 4 screws and the supplied hex key (Figure 12).

9.2.2 INSTALLING THE CONTROLLER WITH VELCRO ATTACHMENT SYSTEM

Wrap the wheelchair tube with the Velcro tape (Figure 13).
Pull the Velcro tight and fold it over its counterpart, securing it
KLAXON Mobility GmbH - EN
KLAXON TWIST device - End User's Manual (EN) - rev. 1.5 of 2023.02.08
Velcro
Figure 11
Quokka®
Figure 12
Figure 13
19