Linking Steps - Lateral Linking System Klaxon - Klaxon TWIST Gebrauchsanleitung

9.5.1 LINKING STEPS - LATERAL LINKING SYSTEM KLAXON®
Throughout the linking phase, make sure to be on a flat area, as free as possible of
unevenness in the terrain and away from dangers to the safety of the person and of others.
Be careful not to squeeze or entrap your fingers during the linking operations. Potential
finger traps and squeezing points are shown in chapter 21.
Loose both the clamps' lever screws (Figure 38 Letter G) enough to let the forks' tubes slide in easily and
without interferences (Figure 39).
Insert the forks' tubes into the clamps (Figure 38 Letter F) according to the distance indicated by the
installation technician. It is important to ensure that the forks protrude from the rear of the clamps for at
least 30 mm and to the same extent on both sides (Figure 40).
Verify that the forks are correctly and evenly inserted. In case something is wrong correct the insertion and
then proceed as follows (Figure 40).
> 30 mm
Tight both the clamps' lever screws until the forks are safely and strongly fixed (Figure 41).
Verify that the forks are correctly secured so that they cannot move and so that they cannot slide out of the
clamps during use. In case the forks are not fixed enough, tighten more the clamps' lever screws until they
meet the requirement then proceed as follows.
After having inserted the forks, the device will be as shown in Figures 42 e 43.
In order to proceed with the TWIST connection please follow the instruction from chapter 10.
34
KLAXON Mobility GmbH - EN
KLAXON TWIST device - End User's Manual (EN) - rev. 1.5 of 2023.02.08
Figure 39
Figure 40
Figure 41