Use; Turning Off And Releasing From The Wheelchair - Klaxon KLICK electric-Serie Gebrauchsanleitung

M
Pressing the " " button again for two times will display the time the device has been on, in minutes (TIME – number 3).
M
Pressing the " " button again for three times will display the maximum speed (ODO MAX – number 2); pressing the "
display in the same screen the average speed (ODO AVG).
To reset trip data, hold down the "
C. Screen Backlighting
+
Hold the " " button for 5 seconds to turn on the screen backlight.
To turn off the backlight, press the "
When the device is turned off, the light is also automatically switched off.
D. Speed Hold Function
-
Press the " " button for 5 seconds to turn on the speed hold function. This function accelerates the device up to a speed of 4.5 km/h and
holds it as long as the button is pressed.
When the button is released, the device instantly stops accelerating.
Every action and/or tampering of the display to change performance and KLICK's security is strictly prohibited. The sole and
DANGER
only actions possible are those specified in paragraph 11.2 of this User's Manual.
NOTE: For further information on the display, see www.klaxon-klick.com or contact an authorised KLAXON dealer.

11.3 USE

Figure 30 shows the Standard handlebar of the Klick device and it identifies the elements that make it up (listed below).
1. Handlebar
2. Accelerator control
3. Reverse button
4. Display
5. Brake lever
Once the device has been installed, the display has been turned on and a speed has been selected, use the accelerator control to make the device
start to move (Figure 31.1). To stop the device, use the brake lever. The KLICK brake is equipped with an additional safety device which deactivates
the motor when the lever is operated (Figure 31.2).
The device is equipped with reverse as standard equipment. To use reverse, press the green button once, then press the accelerator to start moving
the device backward.
To return to the forward operation, release the accelerator and press the green button only once.
The reverse button has only luminous warning systems to show whether it is selected or not.
CAUTION This is shown by the button itself: when the button is fully extended (Figure 32) the reverse gear is OFF (light GREEN off).
When the button is fully pressed (Figure 33) the reverse gear is ON (light GREEN on).
After inserting the battery in its housing and locked by turning the key, remove it and put it in a safe place. It is absolutely
CAUTION
forbidden to use the KLICK device with the key insert in the security block.
The brake lever, the accelerator control, the reverse button and the display can be installed either on the left or on the right side of the handlebar
according to the user's preference.
For installation and positioning of controls (display, accelerator control, reverse button, brake lever), contact an authorised
DANGER
KLAXON service centre.
DANGER Before using reverse to move the device, make sure that there are no persons, obstacles, stairs, slopes behind the wheelchair.
At each restart pay maximum attention, before accelerating, to check if forward or reverse operation is currently selected,
DANGER
especially when close to obstacles, drop-offs and any other kind of danger.
If obstacles, drop-offs and dangers are too close to be safe, turn off the KLICK device and manually move the wheelchair to
DANGER
a safe place.

11.4 TURNING OFF AND RELEASING FROM THE WHEELCHAIR

To perform the operation properly, carefully follow the following instructions.
Stop the wheelchair on a flat surface.
Apply the brake on the wheelchair.
Turn off the display by pressing and holding the "
12
KLAXON Mobility GmbH - ENG
M -
" and " " buttons together for 5 seconds.
+
" button for 5 seconds again.
M
" button for 5 seconds.
KLICK electric series Manual (ENG) - rev.6.3 of 25.05.2020
M
" button again will