Herunterladen Inhalt Inhalt Diese Seite drucken

How To Install The Twist To The Front Of The Wheelchair; Engagement Of The Twist When Installed At The Front - Klaxon TWIST Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

10. HOW TO INSTALL THE TWIST TO THE FRONT OF THE WHEELCHAIR

The TWIST is designed to be used and therefore to be installed to the wheelchair in various positions on the
wheelchair's frame. Each of these different applications are designed to meet precise user's needs and driving
requirements.
Always carry out the linking operation on a flat surface and if possible with the wheels of
the wheelchair and of the TWIST lying on a smooth surface.
It is very dangerous to carry out the linking operation of the TWIST to the wheelchair if the
Controller/Handlebar Control is switched on. Make sure all the controls are switched off
before proceeding.
Before switching on the device make sure that the controls are mounted on the wheelchair
(Controller) or on the device (Handlebar Control). Only proceed with switching on the controls
when the TWIST linking procedure has been completed.
Once the TWIST is installed to the wheelchair, make sure that only the control you intend to
use is activated. Make sure that any other controls are switched off.
It is advisable to avoid using the device when the Controller's/Handlebar Control's battery
is running low as, if its battery runs out, the TWIST will perform a safety stop and can then
only be moved by manual push (no function is active when the Controller is switched off).
Before linking the TWIST, ensure that the battery is present and that it is inserted correctly
and completely into its slot.
If the battery is not inserted in the TWIST, the latter will become unbalanced and therefore
CAUTION
unstable on its stand.
If the battery is not fully inserted in its housing, it may impede the rotation of the steering
system.

10.1 ENGAGEMENT OF THE TWIST WHEN INSTALLED AT THE FRONT

The following instructions apply both to the front installation with the Central Linking System and to the front
installation with the Lateral Linking System.
Insert the Linking System by following the instructions in subsections 9.4.1 and 9.5.1 (Figure 58).
KLAXON Mobility GmbH - EN
KLAXON TWIST device - End User's Manual (EN) - rev. 1.5 of 2023.02.08
Figure 58
41

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis