In Case Of Problems With The Handlebar Control Connection; Driving With The Twist Installed At The Rear - Klaxon TWIST Gebrauchsanleitung

When using the Web App accessory as a display, the smartphone or any other electronic
device they must absolutely be attached to the wheelchair/handlebar. Always use the TWIST
device only with both hands free and available for driving.
Before unmounting the handlebar from the TWIST or before linking and unlinking the device,
always ensure that the Handlebar Control is switched off.

In case of problems with the Handlebar Control connection

In the event that the Twist does not restart moving, stops or does not execute commands make sure to be in a
location away from danger and follow the following steps: switch the Handlebar Control off and on again. If the
problem persists: switch the Handlebar Control and the Twist off and on again. If the above steps do not solve
the problem: Do not use the device and contact an authorised KLAXON service centre.
Do not cover the Handlebar Control (Figure 17 Letter A) with the hand while driving. A hand
placed on the Handlebar Control could reduce the range of the Bluetooth signal and lead to
a possible disconnection from the device.
How to reduce the backlash between the Linking System and the device
It is possible, should it be considered necessary, to reduce the backlash between the device and the Linking
System by tightening a knob screw (Figure 17 Letter K) supplied with the handlebar. Once the TWIST is installed,
it is possible to reduce the backlash by screwing the knob screw by hand into its appropriate seat (Figure 1
Letter H) until it is completely tightened (Figure 112 Letter A). Subsequently, in order to unlink the TWIST device
from the Linking System, it will be necessary to first unscrew the screw (Figure 112 Letter B) of a few turns, or
until the system is free from the restriction.
A
When linking and unlinking the device, always ensure that the knob screw does not obstruct
CAUTION the insertion of the Linking System. In this case, simply unscrew the knob screw a few turns
until the Linking System engages without resistance.
Make sure that the knob screw is tightened enough. If it remains loose, it could detach
during the usage.

14.4 DRIVING WITH THE TWIST INSTALLED AT THE REAR

The TWIST installed at the rear does not allow the front castor wheels of the wheelchair to be lifted mechanically
off the ground. For this reason, the use of the rear-installed TWIST is recommended on terrain with no bumps or
small steps that could block the front wheels of the wheelchair, causing the wheelchair to catapult the passenger
dangerously forward.
In the rear-installed configuration, the TWIST does NOT use the electronic features that
automatically reduce speed during curves as well as the automatic stop of the motor thrust
when exceeding a steering angle of more than 90°. It is therefore recommended to reduce
speed via the Controller before starting a curve.
It is advisable to perform the first driving tests always and only on flat, obstacle-free terrain.
68
KLAXON Mobility GmbH - EN
KLAXON TWIST device - End User's Manual (EN) - rev. 1.5 of 2023.02.08
B Figure 112