Manual Linking Of The Twist To The Rear Of The Wheelchair - Klaxon TWIST Gebrauchsanleitung

12.1 MANUAL LINKING OF THE TWIST TO THE REAR OF THE WHEELCHAIR

It is very dangerous to carry out the linking operation of the TWIST to the wheelchair if the
Controller is switched on. Make sure the Controller is switched off before proceeding. Switch
on the Controller only when the TWIST linking procedure has been completed.
Always carry out the linking operation on a flat surface and, if possible, with the wheels of
the wheelchair and the rubbers of the TWIST front kickstand resting on a smooth surface.
The Controller must never be switched on if it is not connected to the wheelchair.
Once the TWIST is installed to the wheelchair, make sure that only the Controller is
activated. Make sure that any other controls are switched off.
It is advisable to avoid using the device when the Controller's battery is running low as, if its
battery runs out, the TWIST will perform a safety stop and can then only be moved by manual
push (no function is active when the Controller is switched off).
Always perform this procedure with the brakes of the wheelchair engaged.
Turn on the TWIST by pressing the button on the battery.
Grab the TWIST from the handle (Figure 97).
Place the TWIST on its front kickstand (Figure 48 Letter F). (Figure 98)
Grip the handle and bring the TWIST closer to the hook until the lower pin rests perfectly against the hook
(Figures 99 and 100).
58
KLAXON Mobility GmbH - EN
KLAXON TWIST device - End User's Manual (EN) - rev. 1.5 of 2023.02.08
Figure 97
Figure 98