Linking The Twist At The Front With The Handlebar Already Installed - Klaxon TWIST Gebrauchsanleitung

11.3 LINKING THE TWIST AT THE FRONT WITH THE HANDLEBAR ALREADY INSTALLED

It is very dangerous to perform the operation of mounting the handlebar to the TWIST if the
control is on. Make sure the Handlebar Control is deactivated.
Always carry out the linking operation on a flat surface and if possible with the wheels of
the wheelchair and of the TWIST lying on a smooth surface.
Follow the instructions carefully to prevent the handlebar from hitting the user violently
during the linking operations.
When linking the TWIST, the handlebar must always be held with one hand.
The TWIST with the handlebar engaged may under no circumstances be installed and
uninstalled using only one hand. Always use two hands, one of which must always hold the
handlebar.
Always switch off the Handlebar Control before installing the handlebar and/or TWIST to
the wheelchair.
The Handlebar Control must never be switched on if the handlebar and TWIST are not
installed to the wheelchair.
It is advisable to avoid using the device when the Handlebar Control's battery is running low
as, if its battery runs out, the TWIST will perform a safety stop and can then only be moved
by manual push (no function is active when the Controller is switched off).
When mounting the handlebar and when connecting the Handlebar Control to the TWIST
device, make sure that no other controls in the immediate surroundings are switched on.
A
50
KLAXON Mobility GmbH - EN
KLAXON TWIST device - End User's Manual (EN) - rev. 1.5 of 2023.02.08
B
Figure 77
Figure 78