How To Mount The Handlebar Accessory - Klaxon TWIST Gebrauchsanleitung

11. HOW TO MOUNT THE HANDLEBAR ACCESSORY

Mounting the handlebar on the TWIST can be done in two ways:
with the TWIST already installed to the wheelchair
by mounting the handlebar on the TWIST before linking it to the wheelchair.
It is very dangerous to mount the handlebar on the TWIST if the control is on. Make sure the
Handlebar Control is deactivated before proceeding.
Always perform this procedure with the brakes of the wheelchair engaged.
Always carry out the mounting operation on a flat surface and if possible with the wheels of
the wheelchair and the TWIST lying on a smooth surface.
General Information
The Handlebar Control (Figure 17 Letter A) is equipped with a battery that guarantees approximately 15 hours of
use. The LED bar indicates the status of the Handlebar Control:
A
The lit LEDs indicate the battery charge level of the Handlebar Control (Figure 67 Letter A).
The flashing of the LEDs indicates that the Handlebar Control is not connected to the TWIST (Figure 67
Letter B).
Lit, non-flashing LEDs indicate that the Handlebar Control is connected and ready for use (Figure 67 Letter
C).
Do not leave the Handlebar Control with its battery empty for long periods.
Always switch off the Handlebar Control when not in use, during the mounting phases on the
TWIST or when using other driving controls.
Do not clean the control with solvents or products not recommended for plastics. Before
applying, check the instructions of the chosen product to ensure that it is compatible.
Do not get the Handlebar Control wet or immerse it in water.
Use only the supplied battery charger to charge the Handlebar Control.
Always switch off the control before removing the handlebar and/or TWIST from the
wheelchair.
The control must never be switched on if the handlebar and TWIST are not installed to the
wheelchair.
46
KLAXON Mobility GmbH - EN
B
KLAXON TWIST device - End User's Manual (EN) - rev. 1.5 of 2023.02.08
C
Figure 67