Instructions For Maintenance And Servicing; Charging The Twist Battery; Charging The Controller Or The Handlebar Control's Battery - Klaxon TWIST Gebrauchsanleitung

15. INSTRUCTIONS FOR MAINTENANCE AND SERVICING

15.1 CHARGING THE TWIST BATTERY

Switch off the TWIST by pressing the button on the battery.
Connect the battery charger to the domestic power socket.
Lift the rubber cap protecting the battery terminal and connect the plug to the battery of the TWIST.
The battery LEDs will light up in sequence and the LED on the charger will glow red until the battery is fully
charged.
When the battery is fully charged, the battery LEDs will all remain lit without flashing and the charger LED
will glow green.
Disconnect the battery charger from the wall socket and from the battery and put the protective cap on the
connector back on.
To ensure that the charge has been completed, press the battery button, turn it on and check that all 4
LEDs are lit.

15.2 CHARGING THE CONTROLLER OR THE HANDLEBAR CONTROL'S BATTERY

Micro-USB Type B
Switch the control off by pressing the button.
Connect the battery charger to the domestic power socket.
Connect the mini USB connector to the control.
The LEDs of the control will light up indicating the charge level of the control.
When the battery is fully charged, the battery LEDs will all switch off.
Disconnect the charger from the wall socket and from the control.
To ensure that the charge has been completed, press the control button by switching it on and check that
all 4 LEDs are all lit.
KLAXON Mobility GmbH - EN
Micro-USB Type B
KLAXON TWIST device - End User's Manual (EN) - rev. 1.5 of 2023.02.08
Figure 114
Figure 115
71