Driving The Twist With The Handlebar When Installed At The Front - Klaxon TWIST Gebrauchsanleitung

CAUTION The wireless control must always be firmly mounted to the wheelchair (see section 9.2).

14.3 DRIVING THE TWIST WITH THE HANDLEBAR WHEN INSTALLED AT THE FRONT

For the installation of the handlebar please read chapter 11.
The front-installed TWIST with the handlebar accessory equipped allows the front castors of the wheelchair to
be raised off the ground. For this reason this mode of use allows you to move around safely even on uneven
terrain.
Before driving:
Make sure all the controls are switched off.
Make sure the TWIST is installed to the wheelchair and that the wheelchair has its front castors raised off
the ground (see chapters 10 and 11).
Make sure the TWIST is turned on by pressing the appropriate button on the battery. Two short acoustic
signal will be emitted by the TWIST.
Make sure the handlebar is securely mounted on the TWIST.
Make sure the Handlebar Control has been turned on by pressing the appropriate button on the control.
The LEDs will light up and flash until the connection with the TWIST is made. A short acoustic signal will be
emitted to confirm the successful connection, while the LEDs of the control will remain lit without flashing.
Start driving and speed control
Use the accelerator to start driving and to set the desired speed within the maximum limit of 15 km/h. The
accelerator can be configured by the dealer to brake the TWIST at the moment the lever is released (Motor
Brake function). This function can be disabled completely. This driving option can be adjusted in intensity via
the KLAXON Web App.
Adjusting the power delivery
The level of power delivery during acceleration can be adjusted via the Web app. A driving mode with smooth
acceleration or one with a powerful acceleration can be set according to the user's personal driving needs.
Set the desired maximum speed
Using the Web app, it is possible to set the desired speed limit. The maximum speed that can be set is 15 km/h.
The minimum speed that can be set is 6 km/h.
Proceed in reverse:
To proceed in reverse:
Rotating the handlebar beyond 90 degrees makes the reverse function active and not enabled. An acoustic
signal (Beep) will be emitted to indicate that the mode has been changed.
Press the accelerator all the way down to the maximum speed position to enable the reverse gear. Release
the accelerator. Press the accelerator gently to start the reverse motion. Please note that speed will be
limited to 3 km/h.
The device will automatically brake when the accelerator is released.
To return to the forward motion:
Release the accelerator.
Turn the handlebar to the forward drive position. An acoustic signal (beep) will be emitted to indicate the
mode change.
Proceed to drive forward normally.
Monitoring driving information via smartphone
It is possible to use your smartphone as a dashboard to display driving parameters in real time. By attaching
the smartphone to the wheelchair and activating the KLAXON Web App on the Dashboard page, it is possible
to display the travel speed, the number of kilometres travelled, the battery charge level of the TWIST and of the
connected control, and the remaining range of kilometres in real time.
KLAXON Mobility GmbH - EN
KLAXON TWIST device - End User's Manual (EN) - rev. 1.5 of 2023.02.08
67