Klaxon TWIST Gebrauchsanleitung Seite 29

Bend the two upper handlebars by 90° (Figure 28).
Release the fixing lever (Figure 26 Letter C) and lower the handlebar into its seat to shorten it (Figure 29).
Re-engage the lever (Figure 26 Letter C)
Disarm the central joint lever (Figure 26 Letter D)
Slowly fold the two parts of the handlebar, while taking care to accompany the brake cable sheath (Figure
26 Letter E), , which is located inside it, avoiding straining it during folding.
To reopen the entire handlebar, perform the same operations in reverse. Always take great care not to bend
the brake cable sheath, and to accompany it everytime during the operation.
Once the handlebar has been mounted, always check that the mechanical brake is working
properly before using the device.
If the brake sheath is strained during the opening and closing operations of the handlebar,
there is a risk of damaging the mechanical brake, and rendering it inoperative. If this
happens, do not use the device and contact a KLAXON service centre.
If the brake cable is damaged or does not work, the mechanical brake may not work. Do not
use the device and contact a KLAXON service centre.
The adjustment of the brake lever may only be carried out by an authorised KLAXON
technician. An overtightened brake can cause the vehicle to roll over if the brake lever is
squeezed too hard.
28
KLAXON Mobility GmbH - EN
KLAXON TWIST device - End User's Manual (EN) - rev. 1.5 of 2023.02.08
Figure 28
Figure 29