Klaxon TWIST Gebrauchsanleitung Seite 64

When using the TWIST rear-installed, the maximum step that can be negotiated is the one
declared by the wheelchair manufacturer. Always switch off the power supply to the motor
when negotiating a step and switch to manual driving mode.
When the device is installed at the front, the maximum step that can be negotiated is 30
mm.
The TWIST may only be used on routes with inclinations of no more than 6° / 10%.
At high speeds the user may lose control of the wheelchair and a tip over may occur. Never
exceed the maximum speed of 15 km/h in handlebar mode (6 km/h in Controller mode)
when going uphill or downhill. Avoid collisions in general.
Do not lean the TWIST against steps or obstacles higher than 120 mm, as this could
NOTE damage the plastic chassis. Below 120 mm it will be the tyre that will safely lean against
the obstacle (Figure 108).
The motor of the TWIST device does not perform any braking and/or blocking action when
the device is not in motion (recorded speed 0 Km/h). This also refers to the braking action
performed by the Electronic Brake System (EBS) when the device stops (reaches 0 km/h). It
is therefore necessary to act on the manual wheelchair by actively blocking its movement.
It is also necessary to act on the manual wheelchair to keep it stationary in position. If
the handlebar is used, it is also possible to act on the mechanical and parking brake of
the TWIST (provided that the handlebar is properly connected to the device) to block the
movement and keep the wheelchair locked in position.
KLAXON TWIST device - End User's Manual (EN) - rev. 1.5 of 2023.02.08
KLAXON Mobility GmbH - EN
30 mm
>30 mm
Figure 107
Figure 108
63