Setting Up/Adjusting The Lora Connection - Dräger X-node Technisches Handbuch

en |
Operation and controls
Individual alarm limits are adopted for sensors with the same part
number.
5.6.3

Setting up/adjusting the LoRa connection

With the X-node, it is possible to send the measured data to a server
application via a LoRa network. The app can be used to view or
change all the necessary information for setting up such a
connection. Guidelines which illustrate how a device can be
integrated into a LoRa network can be found in a separate section
(see "Integration into the LoRa network", page 74).
Activating/deactivating LoRa
The LoRa module of the X-node can be activated or deactivated via
this setting.
It takes several minutes until the device is identified again in the
LoRa network and the "Connected" status is shown.
64
Changing the transmission interval
The interval at which the measurement data is transmitted to the
configured LoRa network.
Technical manual |
Dräger X-node