Overview: Standard Display - Nouvag OFA-Drill Bedienungsanleitung

7.3

Overview: Standard display

A
B
C
D
E
E
A) Information Line
Information and error messages are displayed here. Display is illuminated red when error messages
are displayed.
B) Program
Shows the selected program number.
C) Pump
The numerical value shows the pump flow rate in percent and the drop symbol together with the
on/off indication shows if the pump is in stand-by mode or switched off.
D) Rotational direction of the motor
The arrow indicates the rotational direction set for the motor. The rotation direction can be changed
by pressing the button "FOR/REV" on the pedal. When using a micro saw no rotation direction is
indicated.
E) Current speed
At stand still of the motor the set maximum speed is displayed. As the motor starts running by
pressing the pedal, the evolving speed is shown in real-time.
F) Name of the handpiece or corresponding transmission ratio
Shows name of the handpiece used or the selected transmission ratio. (See also 7.4.1, "Selecting
handpiece or transmission ratio")
G) Speed range
Shows speed range of the handpiece used when motor is standing still. With running motor the speed
range display is blinded out.
H) Maximum torque
Shows maximum torque setting of the used handpiece.
I) Current torque
Bar graph providing a graphical representation of the current torque. All bars active means max.
torque reached.
The pump does not begin to operate until the motor has been activated by pressing the pedal.
10 OFA-Drill operating instructions, ref. 31595, V49/15
F
G
H
F
G
H
I