Service Schedule; Handover Confirmation - Viking iMow MI 632 Gebrauchsanleitung

Fault:
Unmown grass at edge of mowing area
Possible cause:
– Edge mowing switched off
– Perimeter wire routed inaccurately
– Grass is out of reach of mowing blade
Remedy:
– Mow the edge once or twice per week
( 11.14)
– Check the routing of the perimeter wire
( 11.14); check the clearances with
the iRuler ( 12.5)
– Cut the unmown areas regularly using a
suitable grass trimmer
Fault:
No wire signal
Possible cause:
– Docking station switched off – no LED
illuminates
– Docking station not connected to mains
supply – no LED illuminates
– Perimeter wire not connected to the
docking station – red LED flashes
– Break in perimeter wire – red LED
flashes
– Robotic mower and docking station are
not linked
– Electronics fault
Remedy:
– Switch on the docking station (
– Check power supply to the docking
station ( 9.5)
– Connect the perimeter wire to the
docking station ( 9.7)
– Search for wire break (
repair perimeter wire using wire
connectors ( 12.14)
– Link robotic mower and docking station
( 11.16)
– Contact a VIKING specialist dealer ( )
160
Fault:
The robotic mower is not receiving any
GPS signal
Possible cause:
– The connection to the satellites is
currently being established
– 3 or fewer satellites within range
– The machine is in a dead spot
Remedy:
– No further action required; it can take a
few minutes for the connection to be
established
– Avoid or remove obstacles that might
be blocking the signal (e.g. trees,
canopies)
Fault:
The robotic mower cannot establish a
mobile radio connection
Possible cause:
– The mowing area is in a dead spot
– The M2M service contract has expired
– The radio module is not activated
Remedy:
– Extend the contract at a VIKING
specialist dealer ( )
– Have the radio module activated by a
VIKING specialist dealer ( )
Fault:
13.1)
The robotic mower cannot be reached
using the app
Possible cause:
– Radio module inactive
16.7), then
– Robotic mower in standby mode
– No Internet connection
– Robotic mower not associated with the
correct e-mail address
Remedy:
– The radio module is switched off during
homing and docking, it is then activated
again and the robotic mower can be
reached
– Activate the robotic mower by pressing
the button, set "GPRS" energy mode
( 11.11)
– Connect the device on which the app is
installed to the Internet
– Correct the e-mail address (

26. Service schedule

26.1 Handover confirmation

0478 131 9931 B - EN
10.)