Manual Mowing; Docking The Robotic Mower - Viking iMow MI 632 Gebrauchsanleitung

● Ending mowing:
When the selected end time is reached,
the robotic mower travels to the
perimeter wire and comes to a
standstill. Return the machine to the
docking station to recharge the battery
and confirm the displayed message.
( 24.)
A running mowing operation can be
ended manually at any time using the
STOP button. ( 5.1)
If the battery runs flat before the
selected end time, the mowing
operation is shortened accordingly.

15.6 Manual mowing

The impact sensor and edge
limitation are disabled during
manual mowing.
● Charge the battery if necessary
( 15.8)
● Remove the control panel (
● Activate the Hand control command
( 11.5)
● Move and steer the robotic
mower using the control pad.
Two forward speeds are
available:
Slow – press button lightly
Fast – press button firmly
● Always ensure sufficient distance
between the mowing deck and your feet
before activating the mowing blade –
always walk behind the robotic mower.
( 4.2)
0478 131 9931 B - EN
● To activate the mowing blade,
press and hold the OK button
with your right thumb, then press
the Mow button with your left
thumb. The mowing blade rotates
for as long as the Mow button is
pressed.
● During manual mowing, keep the Mow
button pressed down with your left hand
and operate the control pad with your
right hand.
● To deactivate the mowing blade,
release the Mow button.
● Charge the battery after manual
mowing. (

15.7 Docking the robotic mower

Docking during automatic operation:
The robotic mower automatically travels to
the docking station when the active time
ends or when the battery is discharged.
15.2)
Forcing docking:
● If necessary, insert the control panel
( 15.2)
● If necessary, switch on the
docking station (
● Activate the command Drive to
docking station. (
During a mowing operation, the
Home button on the docking
station can be pressed as an
alternative.
● MI 632 C, MI 632 PC:
Send the robotic mower to the docking
station in the app. (
● No LED must illuminate on the docking
station after docking. (
15.8)
13.1)
11.5)
10.)
13.1)
After docking, no further mowing
operation takes place in the current
active time.
Manual docking:
● Steer the robotic mower to the docking
station using the control panel – remove
the control panel for this purpose
( 15.2) and activate the Hand
control ( 11.5) command.
or
● Push the robotic mower into the
docking station by hand.
Lift the robotic mower slightly by the
carrying handle (1) and relieve the weight
on the drive wheels. Push the machine,
resting on its front wheels, into the docking
station.
● Insert the control panel (
● No LED must illuminate on the docking
station after docking. ( 13.1)
15.2)
141