Viking iMow MI 632 Gebrauchsanleitung Seite 160

Fault:
The robotic mower fails to mow after the
commands "Start mowing" or "Start time-
delayed mowing" have been called up
Possible cause:
– Insufficient battery charge
– Rain detected
– Control panel not correctly inserted
– Message is active
– The Home button on the docking station
has been pressed – Homecall is active
Remedy:
– Charge the battery ( 15.8)
– Set the rain sensor ( 11.12)
– Insert the control panel (
– Rectify displayed fault and confirm the
message with OK ( 11.9)
– Press the Home button to switch off
Homecall or repeat command following
docking
Fault:
The robotic mower is not working and
nothing is shown in the display
Possible cause:
– Machine is in standby
– Battery defective
Remedy:
– Press any button to wake up the robotic
mower – the status screen appears
( 11.2)
– Replace the battery ( )
Fault:
The robotic mower is noisy and vibrates
Possible cause:
– Mowing blade is damaged
158
– Mowing deck is very dirty
Remedy:
– Replace the mowing blade – remove
any obstacles from the lawn (
( )
– Clean the mowing deck (
Fault:
Poor mulching or mowing result
Possible cause:
– Grass is too high in relation to the
cutting height
– Lawn is extremely wet
– Mowing blade is blunt or worn
– Active times insufficient, mowing
15.2)
duration too short
– Size of mowing area set incorrectly
– Mowing area with very high grass
– Long periods of rain
Remedy:
– Adjust the cutting height (
– Set the rain sensor (
Change the active times (
– Replace the mowing blade (
( )
– Extend or add active times (
Extend the mowing duration (
– Create a new mowing plan (
– For neat mowing results, the robotic
mower needs up to 2 weeks, depending
on the size of the lawn.
– Allow mowing during rain (
Extend the active times (
Fault:
Display in a foreign language
Possible cause:
– Language setting has been changed
Remedy:
– Set the language (
Fault:
Brown (earthy) patches appear in the
mowing area
16.4),
Possible cause:
16.2)
– Mowing duration is too long in relation
to the mowing area
– Perimeter wire has been routed with
excessively tight radii
– Size of mowing area set incorrectly
Remedy:
– Reduce the mowing duration (
– Correct the routing of the perimeter wire
(
– Create a new mowing plan (
Fault:
Mowing operations are significantly
shorter than usual
Possible cause:
9.3)
– Grass is very high or too wet
11.12)
– Machine (mowing deck, drive wheels) is
11.7)
very dirty
16.4),
– Battery has reached end of service life
Remedy:
11.7)
– Adjust the cutting height (
11.8)
Set the rain sensor (
11.8)
Change the active times (
– Clean the machine (
– Replace the battery – observe
corresponding recommendation in the
11.12)
display ( ), (
11.7)
Fault:
The robotic mower is docked, the battery is
not charging
Possible cause:
– The battery does not need to be
charged
11.11)
– Docking station not connected to power
supply
9.6)
9.3)
11.12)
11.7)
16.2)
11.9)
0478 131 9931 B - EN
11.8)
11.8)