Possible Cause; Checking Installation - Viking iMow MI 632 Gebrauchsanleitung

Continue initial installation by
pressing the OK button.
MI 632 C, MI 632 PC:
"GPRS" energy mode is activated
following successful linking.
( 11.11)
Interrupted reception
The robotic mower receives no
wire signal:
The text "No wire signal"
appears on the display.
The robotic mower receives a
faulty wire signal:
The text "Check wire signal"
appears on the display.
The robotic mower receives a
reversed-polarity wire signal:
The text "Connections swapped
or iMow outside" appears on the
display.

Possible cause:

– Temporary malfunction
– Robotic mower is not docked
– Perimeter wire has been connected
incorrectly (reversed polarity)
– Docking station is switched off or not
connected to mains supply
– Faulty plug connections
– Coiled power cable in the vicinity of the
docking station
– Excessively long perimeter wire ends
– Perimeter wire break
– Extraneous signals such as a mobile
phone or the signal from another
docking station
114
– Live underground cables, reinforced
concrete or disruptive metals in the
ground under the docking station
– Maximum length of the perimeter wire
exceeded ( 12.1)
Remedy:
– Repeat linking without other corrective
action
– Dock the robotic mower (
– Connect the perimeter wire ends
correctly ( 9.7)
– Check the docking station mains
connection, roll out the power cable in
the vicinity of the docking station, do not
set down coiled
– Check the perimeter wire plug
connections, cut off excessively long
perimeter wire ends (
– Check the LED indicator on the docking
station ( 13.1)
– Repair the wire break
– Switch off mobile phones or nearby
docking stations
– Change position of the docking station
or remove interference sources under
the docking station
– Use perimeter wire with larger cross
section (special accessory)
Following the appropriate corrective
action, repeat linkage by pressing
the OK button.
If the measures described above do
not result in a correct wire signal
then contact a VIKING specialist
dealer.

9.9 Checking installation

15.7)
Start the test run by pressing the OK
button – this does not activate the
mowing blade.
9.7)
As the robotic mower follows the edge,
walk behind it and ensure:
– that the robotic mower follows the edge
of the mowing area as planned,
– that the clearances to obstacles and the
borders of the mowing area are correct,
– that docking in and out takes place
correctly.
MI 632 C, MI 632 PC:
The test run is used to define the
home area of the robotic mower.
( 14.5)
0478 131 9931 B - EN