Maintenance And Repairs; 131 9931 B - En - Viking iMow MI 632 Gebrauchsanleitung

A slope inclination of 24° corresponds to a
vertical height increase of 45 cm for a
100 cm horizontal distance.
Beware of the cutting tool
running on for several seconds
before coming to a standstill.
Press the STOP button (
during running operation:
– before making or changing settings in
the menu,
– before adapting the programming,
– before removing the control panel.
Activate the disabling device (
– before lifting or carrying the machine,
– before transporting the machine,
– before removing blockages,
– before carrying out any work on the
mowing blade,
– before checking or cleaning the
machine,
– after hitting a foreign object or if the
robotic mower begins to vibrate
excessively. In these cases, check the
machine, in particular the cutting unit
(blade, blade shaft, blade fastening) for
damage and carry out the necessary
repairs before restarting and working
with the machine.
100
Risk of injury!
Strong vibration is normally an
indication of a fault.
In particular, the robotic mower
must not be operated with a
damaged or bent blade shaft or
mowing blade.
If you do not have the appropriate
expertise, have the necessary
repairs carried out by a specialist
dealer (VIKING recommends
VIKING specialist dealers).
Before leaving the machine unattended,
the safety settings of the robotic mower
must be adapted so that it cannot be
operated by unauthorised persons.
5.1)
( 11.16)
Manual mowing:
Exercise care when starting the machine
and observe the instructions in the
"Manual mowing" section. (
Only work during the day or with good
5.2):
artificial light.
Never mechanically fix buttons on the
machine, especially the Mow button.
The user must always remain behind the
machine. Always keep your feet a safe
distance from the blade.
To prevent the risk of injury due to slipping,
stumbling, etc., never run when mowing.
Be particularly careful when turning the
robotic mower around or pulling it towards
you backwards.
The risk of accidents is higher if the ground
is damp due to increased danger of
slipping.
Particular caution should be exercised
during working in order to prevent slipping.
If possible, avoid manual mowing when
the ground is damp.
Always ensure good stability on slopes
and avoid mowing on excessively steep
slopes.
Only mow at right-angles to the slope and
never up or down the slope and ensure
that you always stand over the robotic
mower, in order to avoid being run over in
the case of loss of control of the machine.
Objects hidden in the turf (lawn sprinkler
systems, posts, water valves, foundations,
electrical wires, etc.) must be avoided.
Never run over any such foreign objects.
Never steer against obstacles
intentionally. The impact sensor is
disabled during manual mowing.
Do not lean forward and always ensure
that you maintain your balance and a firm
footing on inclines when operating the
machine and its peripherals. Always walk,
do not run.
15.6)

6.9 Maintenance and repairs

Before starting cleaning, repair
or maintenance operations,
activate the disabling device
and park the robotic mower on
firm and level ground.
Disconnect the mains plug of
the power supply unit before
performing any work on the
docking station and the
perimeter wire.
Allow the robotic mower to cool down for
approx. 5 minutes before performing any
maintenance operations.
The power cable must only be repaired or
replaced by authorised electricians.

0478 131 9931 B - EN