Service; Perimeter Wire - Viking iMow MI 632 Gebrauchsanleitung

9. Link iMow and dock:
Following initial operation, the
robotic mower can only be operated
in conjunction with the docking station
supplied.
Following a replacement of the docking
station, of electronic components in the
robotic mower or for operation of the
robotic mower on an additional mowing
area using a different docking station, the
robotic mower and docking station must be
linked.
● Install the docking station and connect
the perimeter wire. ( 9.5), (
Lift the robotic mower slightly by the carry
handle (1) and relieve the weight on the
drive wheels. Push the machine, resting
on its front wheels, into the docking
station.
● After pressing the OK button,
enter the PIN code. The robotic
mower will then search for the
wire signal and save it automatically.
This process takes several minutes.
( 9.8)
No PIN code is required in the
safety level "None".
0478 131 9931 B - EN

11.17 Service

1. Blade change:
Installation of a new mowing blade is
confirmed with OK.
If the blade has been in use for
more than 200 hours, the message
"Replace mowing blade" appears.
( 16.4)
2. Find wire break:
If the red LED on the docking station
flashes, there is a break in the perimeter
9.7)
wire. ( 13.1)
The assistant to find the break is activated
with OK.
● Finding wire break (
3. Reset settings:
The robotic mower is reset to the factory
defaults with OK, the installation assistant
is restarted. (
● Enter the PIN code after pressing
the OK button.
No PIN code is required in the
safety level "None".
16.7)
9.4)

12. Perimeter wire

Before routing the
perimeter wire,
particularly prior to initial
installation, read the
entire section and plan the wire
routing in detail.
Perform initial installation using the
installation assistant. (
Should you require support, your
VIKING specialist dealer will be
pleased to assist you with
preparation of the mowing area and
installation of the perimeter wire.
Check the installation of the perimeter wire
before it is finally secured in place. (
Adjustments to the wire routing are
generally necessary in the vicinity of
corridors, confined areas or no-go areas.
Deviations can occur if
– the technical limits of the robotic mower
are reached, for example with very long
corridors or when routing the perimeter
wire in the vicinity of metal objects or
above metal under the lawn,
– if the mowing area is structurally altered
for using the robotic mower.
9.)
9.9)
129