Viking iMow MI 632 Gebrauchsanleitung Seite 109

In conjunction with an external
docking station, a separately
available accessory is required for
offset drive home (AED 600).
( 11.14)
More information can be obtained
from your VIKING dealer.
The docking station (1) must be installed
as shown for docking in and out to take
place correctly. The areas around the
docking station and outside of the
perimeter wire must be flat and freely
travellable. Remove any bumps or
depressions.
Minimum clearance to the mowing area:
A = 50 cm
Width of the free area: B = 44 cm
Maximum clearance to the mowing area:
C = 12 m
0478 131 9931 B - EN
Fastening the docking station:
Fix the docking station (B) into position at
the chosen location using four pegs (L).
The ground at the chosen location should
be horizontal. The docking station must
not be inclined by more than 2 cm
rearwards or 8 cm forwards. Never bend
the floor plate. Any unevenness must be
removed under the floor plate so that it
fully contacts the ground.
Pull the cover (1) apart slightly on the left
and right as illustrated and remove
upwards.
107