Viking iMow MI 632 Gebrauchsanleitung Seite 136

In corridors, the lawn is only mown
along the path of the perimeter
wire. If necessary, activate
automatic edge mowing or mow the
corridor area manually on a regular
basis. ( 11.5), ( 11.14)
The specified wire clearances are
adapted to routing of the perimeter
wire on the lawn area.
Requirements:
– Minimum width (space requirement):
between solid obstacles: 108 cm
between paths that can be travelled on:
27 cm.
In longer corridors, a slightly
increased space requirement
should be taken into account
depending on the ground
conditions. Longer corridors should
always be installed as centrally as
possible between obstacles.
– The corridor can be travelled on freely.
– Offset drive home (corridor) is
deactivated. ( 11.14)
– At least 1 starting point must be
defined in the area of the second
mowing area. ( 11.15)
134
The docking station (1) is installed in
mowing area A. Mowing area B is linked
to mowing area A by means of a
corridor (2). The perimeter wire (3) can be
continuously followed by the robotic
mower. In order to mow mowing area B,
starting points (4) must be defined.
( 11.15)
Individual mowing operations can then be
started at the starting points, depending on
the setting (starting frequency).
Start and end of the corridor:
The perimeter wire (1) must be routed in a
funnel shape as illustrated at the start and
end of the corridor (distances A and B on
the iRuler). This installation prevents the
robotic mower from accidentally driving
into the corridor during mowing.
A = 10 cm
B = 17 cm
Installing a corridor:
Wire clearance in corridors: 27 cm
(distance C on the iRuler).
This results in the following space
requirements:
– between high obstacles (> 2 cm –
e.g. walls):
108 cm,
– between paths/obstacles that can be
travelled on (≤ 2 cm – e.g. paths):
27 cm.
0478 131 9931 B - EN