Removing And Installing The Mowing Blade - Viking iMow MI 632 Gebrauchsanleitung

Check the blade width A and blade
thickness B using a slide calliper.
A > 25 mm
B > 1,3 mm
The blade must be replaced if the
measured values are achieved at one or
more points or are outside the permissible
limits.
16.4 Removing and installing the
mowing blade
The mowing blade is designed for a
service life of 200 hours. After this
period, a corresponding message
appears in the display.
● Activate the disabling
device ( 5.2) and wear
gloves.
144
● Tilt the robotic mower onto its side and
lean it securely against a stable wall.
Carefully clean the mowing deck and
mowing blade. ( 16.2)
Removing the mowing blade:
Push in both tabs (1) on the
carrier plate with one hand and
hold. Remove the fastening
nut (2) with your other hand.
Remove the mowing blade together with
the fastening nut.
Installing the mowing blade:
Risk of injury!
Check the blade for damage before
installing. The blade must be
replaced if notches or cracks are
detected or if it is worn. (
The carrier plate and the
fastening nut must also be
replaced if damaged (e.g. broken,
worn). The fastening nut in
particular must engage cleanly in
the carrier plate.
● Clean the blade, carrier plate and
fastening nut prior to installation.
Fit the mowing blade (1) on the carrier
plate (2) as illustrated. Ensure the correct
position of the retainers (3) in the mowing
blade.
16.3)
Screw on the fastening nut (1) as far as
possible. Several clicks are audible during
tightening. Ensure secure seating of the
mowing blade by shaking carefully.
0478 131 9931 B - EN