Maintenance, Cleaning, Repairs And - Viking ME 443 Gebrauchsanleitung

– if tilting of the machine is necessary
when transporting over surfaces other
than grass,
– when pushing the machine to and from
mowing areas,
– before removing the grass catcher box.
– before adjusting the cutting height.
Switch off the motor, disconnect
the mains plug and ensure that
the cutting tool has come to a
complete standstill
– before remedying blockages, including
those in the discharge chute,
– if the cutting tool has hit a foreign object.
The cutting tool must be checked for
possible damage. The machine must
not be operated with a damaged or bent
blade shaft or motor shaft. Risk of
injury through defective parts!
– before you check, clean or carry out
work on the machine (e.g. adjusting the
cutting height, opening or adjusting the
handlebar);
– before leaving the machine unattended;
– before lifting, or carrying the machine;
– before transporting the machine.
– after hitting a foreign object or if the
machine begins to vibrate excessively.
In these cases check the machine, in
particular the cutting unit (blade, blade
shaft, blade fastening) for damage and
carry out the necessary repairs before
restarting and working with the
machine.
0478 121 9920 C - EN
Risk of injury!
Strong vibrations are generally an
indication of a fault.
In particular, the machine must not
be operated with a damaged or
bent blade shaft or mowing blade.
If you do not have the appropriate
expertise, have the necessary
repairs carried out by a specialist
dealer (VIKING recommends
VIKING specialist dealers).
Owing to the voltage fluctuations caused
by this machine during the run-up period,
other devices connected to the same
circuit may be subject to interference in the
case of unfavourable power supply
conditions. In this case, appropriate steps
should be taken (e.g. connection to a
different circuit than the one used by the
affected device, or operation of the
machine using a circuit with a lower
impedance).

4.6 Maintenance, cleaning, repairs and

storage
Before performing any work on
the machine, before adjusting or
cleaning the machine, or before
checking whether the electric cable is
entwined or damaged, switch off the
machine and disconnect the mains plug.
Allow the machine to fully cool down
before storing it in enclosed places,
performing maintenance on it or cleaning
it.
Cleaning:
The complete machine must be cleaned
thoroughly following use. (
Remove accumulated clipping deposits
using a stick. Clean the underside of the
mower with water and a brush.
Never use high-pressure cleaners and do
not clean the machine under running water
(e.g. using a garden hose).
Do not use aggressive cleaning agents.
These can damage plastics and metals,
impairing the safe operation of your
VIKING machine.
In order to prevent fire hazards, keep the
area around the air vents between the
motor hood and housing free from
e.g. grass, straw, moss, leaves or
escaping grease.
Maintenance operations:
Only maintenance operations described in
this instruction manual may be carried out.
Have all other work performed by a
specialist dealer.
If you do not have the necessary expertise
or auxiliary equipment, please always
contact a specialist dealer.
VIKING recommends that you have
maintenance operations and repairs
performed exclusively by a VIKING
specialist dealer.
VIKING specialist dealers regularly attend
training courses and are provided with
technical information.
Only use tools, accessories or
attachments approved for this machine by
VIKING or technically identical parts.
Otherwise, there may be a risk of
accidents resulting in personal injury or
damage to the machine. If you have any
questions, please consult a specialist
dealer.
The characteristics of original VIKING
12.2)
tools, accessories and spare parts are
optimally adapted to the machine and the
user's requirements. Genuine VIKING
37