Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Img.5-15: Coolant shut-off tap and doser
Adjust the flow using the shut-off and dosing tap.
ATTENTION!
Failure of the pump in case of dry running.
The pump is lubricated by the cooling agent. Do not start up the pump without cooling
agent.
INFORMATION
Use a water-soluble and non-pollutant oil as a cooling agent. This can be acquired from author-
ised distributors.
Re-use cooling agents and lubricants.
Respect the environment when disposing of any lubricants and cooling agents.
Follow the manufacturer's disposal instructions.
5.7
Working with the machine
5.7.1
Preparation
WARNING!
For drilling jobs, it is necessary to clamp the workpiece firmly to prevent the bit catching
on the pieces. A machine vice or clamping claws is a suitable clamping device.
Put a wooden or plastic board beneath the workpiece to avoid drilling through to the work table,
vice, etc.
If necessary, adjust the required drilling depth using the depth stop to obtain a constant result.
Please make sure to use a suitable dust suction when treating wood since wood dust may be
health hazardous.
Wear a suitable dust mask when performing works at which dust is generated.
First, select the speed of the bit. This will depend on the diameter of the bit being used and
on the material.
5.8
Drilling
WARNING!
Seizing of clothes and / or hair.
Make sure to wear well-fitting work during drilling work.
Do not use gloves.
If necessary, use a hairnet.
Operation
Version 1.1.4 - 2021-01-04
Shut-off and metering tap of the coolant
Determining the cutting speed and the speed on page 93
Translation of original instruction
B50 GSM
EN
91
Werbung
Inhaltsverzeichnis
