Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Interval
Where?
First after 200
operatingm
hours, then
every 2000
operating
hours
Maintenance
Version 1.1.4 - 2021-01-04
What?
How?
Fill in in the open gear lubrication system of the drill about 2.5
litres of oil.
Switch on the geared drill.
Check the oil level in the inspection glass The sight glass (oil
level dropped) should be set up to be half covered.
For oil change use an appropriate collecting tray of sufficient
capacity.
Unscrew the screw from the drain hole.
Re-fill the gear with gear oil. Approx. consumption 2.5 litres.
Pay attention to the correct level.
Operating material on page 74
original parts or series components expressly authorized by
Optimum Maschinen Germany GmbH. on page 103
Originalbetriebsanleitung
Oil drain plug
Img.7-6: Oil drain plug
Img.7-7: Changing the oil in the gear of the drilling
spindle sleeve
B50 GSM
GB
101
Werbung
Inhaltsverzeichnis
