5
Operation
5.1
Safety
Use the machine only under the following conditions:
The machine is in proper working order.
The machine is used as prescribed.
The operating manual is followed.
All safety devices are installed and activated.
All failures should be eliminated immediately. Stop the machine immediately in the event of any
anomaly in operation and make sure it cannot be started up accidentally or without authoriza-
tion
Notify the person responsible immediately of any modification.
Safety during operation on page 71
5.2
Control and indicating elements
Drill chuck protection
Coolant pump
Operation
Version 1.1.4 - 2021-01-04
Img.5-1: Geared drill B50 GSM
Translation of original instruction
Gear selector for
speed increments
Control panel
Spindle sleeve lever with switch
for spindle sleeve feed
Drilling table
Clamping lever for table turn
Crank for table height
adjustment
B50 GSM
EN
83