Optimum OPTIdrill B 50GSM Betriebsanleitung Seite 86

Main switch
Interrupts or connects the power supply.
Gear selector switch
The speed of the drill spindle is set by actuating the gear selector switch and the step counter
switch motor.
ATTENTION!
Changing the speed when the bit-holder spindle is turning may cause damage to the
machine.

Disconnect the machine before changing the speed.

Wait until the bit-holder spindle has come to a complete halt.
Img.5-4: Gear selector switch
Use the JOG button (direct run) to facilitate the engaging of the indexing positions.
INFORMATION
When choosing the right rate, use the speed table on the bit-holder head.
Speed table - for ~50Hz connection
Img.5-5: ~ 50Hz
EN
B50 GSM
86
Gear selector switch
Speed table
Translation of original instruction
Operation
Version 1.1.4 - 2021-01-04