Accident Report; Electrical System; Inspection Deadlines - Optimum OPTIdrill B 50GSM Betriebsanleitung

Covers,

Safety indications and warning signs,

earth (ground) connections.

If you remove protective or safety devices, re-fit them immediately after the completing the
work. Check if they are working properly!
1.14

Accident report

Inform your superiors and Optimum Maschinen Germany GmbH immediately in the event of
accidents, possible sources of danger and any actions which almost led to an accident (near
misses).
There are many possible causes for "near misses".
The sooner they are notified, the faster the causes can be eliminated.
1.15

Electrical system


Electrical specialist on page 65
Have the machine and/or the electric equipment checked regularly. Immediately eliminate all
defects such as loose connections, defective wires, etc.
A second person must be present during work on live components to disconnect the power in
the event of an emergency. Disconnect the lathe immediately in case of failure of the power
supply!
Comply with the required inspection intervals in accordance with the factory safety directive,
operating equipment inspection DGUV, formerly BVG.
The operator of the machine must ensure that the electrical systems and operating equipment
are inspected with regards to their proper condition, namely,
by a qualified electrician or under the supervision and direction of a qualified electrician,

prior to initial commissioning and after modifications or repairs, prior to recommissioning
and at certain intervals.

The deadlines must be set so that arising, foreseeable defects can be detected in time.
The relevant electro-technical rules must be followed during the inspection.
The inspection prior to initial commissioning is not required, if the operator receives confirma-
tion from the manufacturer or installer that the electrical systems and operating equipment com-
ply with the accident prevention regulations. See EC Declaration.
Permanently installed electrical systems and operating equipment are considered constantly
monitored, if they are continually serviced by qualified electricians and inspected by means of
measurements within the scope of operation (e.g. monitoring the insulation resistance).
1.16

Inspection deadlines

Define and document the inspection deadlines for the machine in accordance of the Factory
Safety Act and perform an operational risk analysis in accordance of the Work Safety Act. The
inspection intervals in the maintenance section should be as reference values.
EN
B50 GSM
72 Translation of original instruction
Safety
Version 1.1.4 - 2021-01-04