Accessories And Spare Parts; Checking The Delivery; Function; Device Description - Kärcher KM 100/120 R Bp Originalbetriebsanleitung

Disposal of the worn out vehicle
Vehicles that are no longer fit for service contain valuable recy-
clable materials. We recommend you cooperate with a waste
management company with regard to the disposal of your vehi-
cle.

Accessories and spare parts

Only use original accessories and original spare parts. They en-
sure that the appliance will run fault-free and safely.
Information on accessories and spare parts can be found at
www.kaercher.com.

Checking the delivery

Please report any defects or shipping damage identified on the
vehicle when it is handed over directly to your dealer or depart-
ment store.

Function

The sweeper operates using the direct-throw principle.
1. The rotating side brushes clean corners and edges of the
sweeping surface and convey the waste into the path of the
roller brush.
2. The rotating roller brush conveys the waste directly into the
waste container.
3. The dust swirled up in the waste container is separated by a
dust filter, and the suction fan sucks away the filtered air.
4. Cleaning of the dust filter occurs automatically during opera-
tion.

Device description

Control elements and functional elements
See graphics page for illustrations
Illustration A
Programme selection switch*
1
Adjustment knob for side brush speed
2
Display**
3
Emergency stop switch
4
Work light switch (option)
5
Flashing beacon switch (option)
6
Horn button
7
Driving direction switch
8
Accelerator pedal
9
Key-operated switch
10
Coarse dirt flap pedal
11
Unlock waste container button
12
Water spray system switch (option)
13
Dust filter cleaning button
14
Steering wheel
15
Right cladding
16
Wet sweeping flap
17
Driver's seat (with seat contact switch)
18
Type plate (on the support plate above the battery)
19
Dust filter
20
Storage area
21
Left cladding
22
Button for raising/lowering the waste container
23
Button for opening/closing the waste container flap
24
Home base rail
25
Seat adjustment lever
26
Rear wheel
27
Sealing strip (4 pieces)
28
Roller brush
29
Front wheel (electric drive)
30
Right side brush
31
Battery***
32
Charging cable***
33
Charging plug***
34
Mains cable***
35
Portable charger***
36
22
Driving*
37
Sweeping with a roller brush*
38
Sweeping with roller brush and side brushes*
39
* For a description of this, see chapter Program selection switch
** For a description of this, see chapter Display
*** only KM 100/120 R Bp pack
Note
Not shown are special options that are already fitted when or-
dered ex works or can be retrofitted by the service department,
see chapter Accessories/wear parts.
Program selection switch
Note
The functions are only active when the key-operated switch is in
position "I".
Illustration B
Driving
1
– The machine can be driven to the operating location.
– The roller brush and side brushes are raised and switched
off.
Sweeping with a roller brush
2
– The roller brush is lowered and switched on.
Sweeping with roller brush and side brush
3
– The roller brush and right and left (optional) side brushes are
lowered and switched on.
Illustration C
Display
1
Battery charge status
2
Operating hours counter
3
If the key switch is in position "I", the display shows the following:
● the battery charge status in %
● the operating hours counter
If the display shows one of the following messages, release the
corresponding button or the accelerator pedal:
● W 1 (The unlock waste container button is pressed)
● W 2 (The raise waste container button is pressed)
● W 3 (The lower waste container button is pressed)
● W 4 (The accelerator pedal is depressed)
If the message is still displayed, contact the service department.
If the following message appears on the display, contact the ser-
vice department:
● E ...,
If the battery charge status is < 20%, a warning tone sounds
every 2 min. Charge the battery as soon as possible, see chapter
Charging the battery.
If the battery charge status is < 10%, the roller brush and side
brushes are switched off. Charge the battery immediately, see
chapter Charging the battery.
WARNING
Malfunction due to open panels
Only open the panels when the key switch is on <0> and the key
has been removed.
Opening during operation is prohibited.
Open/close the left/right cladding
Open the left-hand cladding for the following operations:
● Remove/check /install the roller brush, see chapter Remov-
ing/checking/installing the roller brush
● Clean the inside of the machine, see chapter Cleaning the in-
terior of the machine
● Remove/install the left rear wheel, see chapter Removing/in-
stalling the rear wheel
● Replace the fuse, see chapter Removing/installing the fuse
Open the right-hand cladding for the following operations:
● Disconnect/connect the power supply, see chapter Discon-
necting/connecting the power supply
● Charge the battery, see chapter Charging the battery
English
Display
Panels