After Using Your Appliance; Working With The Blender; Adding More Ingredients - Silvercrest SKM 550 B1 Bedienungsanleitung

After using your appliance

1) Switch the appliance off using the rotary
switch r.
2) Turn the continuous shredder 7 anti-clockwise
and remove it.
3) Disassemble the continuous shredder 7 and
clean all parts as shown in the section "Clean-
ing and care".

Working with the blender

WARNING! RISK OF INJURY!
► Allow hot fl uids to cool to a lukewarm tem-
perature (approx. 30 - 40°C) before pouring
them into the blender 4.
WARNING! RISK OF INJURY FROM
SHARP KNIFE/ROTATING DRIVE!
► Never put your hand into the attached
blender 4 while it is running!
Remove the blade from the blender 4 only
►
when it is at a complete standstill.
Only use the blender 4 with the lid fi rmly in
►
position.
► In cases of malfunction, switch the appliance
off and remove the plug from the wall socket.
This will prevent the appliance from becoming
switched on again unintentionally.
Proceed as follows to prepare the appliance for
operation using the blender 4:
1) Press down the release button e and move
the pivot arm t into operating position 3
(see the section "Operating positions").
SKM 550 B1
All manuals and user guides at all-guides.com
2) Remove the protective cover for the blender
3) Position the blender 4 on top of the appliance
4) Add the ingredients.
5) Place the lid onto the measuring jug slightly
6) Turn the rotary switch r to the required setting.

Adding more ingredients

1) Switch the appliance off using the rotary switch r.
2) Rotate the lid of the blender 4 a little (Image I),
or
3) Rotate the measuring jug by 90° and remove
drive hub (turn so that the marking "
the protective cover for the blender drive hub is
in line with the marking " " on the appliance
itself) (Image F).
(so that the marking "
lines up with the marking " " on the appli-
ance).
Turn the blender anti-clockwise until the stop
(so that the marking "
lines up with the marking " " on the appli-
ance itself) (Image G).
–
Maximum fi ll quantity: approx. 1 litre;
–
Foaming liquids, maximum 0.5 litre;
–
Ideal processing quantity for solids: 50 - 100 g.
NOTE
► Take note of the table in the section
"Recommended fi lling quantities".
off set and then turn it until the lid clicks into
place (Image I).
remove the lid and add the ingredients you
want to mix
it. Then gradually add the solid ingredients
using the opening provided for this purpose.
" on
" on the blender 4
" on the blender 4
9
GB