Working With The Kneading Hook, Beater And Whisk; Refilling With Ingredients - Silvercrest SKM 550 B1 Bedienungsanleitung

Working with the kneading
hook, beater and whisk
WARNING! RISK OF INJURY!
► Under no circumstances should you place
your hands or fingers in the mixing bowl
during operation! Danger of injury due to
rotating parts!
► Switch from one accessory to another only
when the drive unit
standstill! After being switched off, the drive
unit will continue to run for a short time.
► In cases of malfunction, switch the appliance
off and remove the plug from the wall socket.
This will prevent the appliance from becoming
switched on again unintentionally.
NOTE
► The appliance may only be used when the
drive hubs not being used are fitted with their
protective covers.
Proceed as follows to prepare the appliance for
operation using the kneading hook
and whisk :
1) Press down the release button
the pivoting arm
(see the section "Operating positions") (Image
A).
2) Set the mixing bowl
base of the mixing bowl
the recesses provided for it on the blender.
3) Press down the release button
the pivoting arm
(Image A).
4) Set the rotary switch
position until the drive unit
position (Image B). If the drive unit
move, it is already in its park position (Fig. 2).
5) Press down the release button
the pivoting arm
(Image A).
SKM 550 B1
is at a complete
, beater
and move
into operating position 4
into place. Check that the
is inserted fully into
and move
into operating position 1
to P and hold it in this
settles in its "Park"
doesn't
and move
into operating position 4
6) If you want to use the kneading hook
the dough deflector into the drive unit
(Image D). Ensure that the hole through which
the kneading hook is inserted is lying over the
mounting hole on the drive unit
7) Depending on the task to be performed, insert
the kneading hook
that they firmly click firmly into the drive unit
8) Add the ingredients you wish to process into
the mixing bowl
NOTE
► While kneading and/or mixing, please note
that the dough in the mixing bowl
crease in volume or will be pressed upwards
by the tool. Take note of the table in the sec-
tion "Recommended filling quantities".
9) Press down the release button
the pivoting arm
position 1 (Image A).
10) Slide the lid onto the mixing bowl
catches on the pivoting arm
11) Turn the rotary switch
Refilling with ingredients
■ Add the ingredients through the hole in the lid
during operation.
Or:
1) Switch the appliance off using the rotary
switch .
2) Set the rotary switch
this position until the drive unit
standstill (Image B).
3) Remove the lid.
4) Press down the release button
the pivoting arm
5) Add the ingredients.
, insert
.
, beater or whisk
.
will in-
and move
down into operating
so that the
click into place.
to the required setting.
to P and hold it in
comes to a
and move
into operating position 5.
GB
so
.
7