Working With The Kneading Hook, Beater And Whisk - Silvercrest SKMP 1300 B3 Bedienungsanleitung

Working with the kneading
hook, beater and whisk
WARNING! RISK OF INJURY!
► Under no circumstances should you place
your hands or fingers in the mixing bowl
during operation! Danger of injury due to
rotating parts!
► Switch from one accessory to another only
when the drive unit is at a complete standstill!
After being switched off, the drive continues
to run for a short time.
► In cases of malfunction, switch the appliance
off and remove the plug from the wall socket.
This will prevent the appliance from becoming
switched on again unintentionally.
CAUTION – PROPERTY DAMAGE!
► When working with kneading hooks
whisk or beater
allowing the appliance to cool down after
10 minutes of operation.
NOTE
► When you are working with the kneading
hook , whisk
lid must be in place. If not, the appliance
will not start.
To prepare the device for tasks involving the knead-
ing hooks , whisk
follows:
1) Push the release lever
the swivelling arm
2) Insert the mixing bowl
mechanisms on the mixing bowl
recess in the base
clockwise (cf. symbols
base ) until it is locked and stable.
SKMP 1300 B3
,
, we recommend
or beater , the drive unit
or beater , proceed as
upwards and move
to the highest position.
so that the locking
fit into the
. Rotate the mixing bowl
and on the
3) Depending on type of application, mount either
the kneading hook
onto the drive shaft
–
Place the kneading hook
beater onto the drive shaft
both metal pins on the drive shaft
the recesses in the inset
–
Push the inset
shaft until the spring is compressed while
rotating the inset a little anticlockwise (direc-
tion ).
–
Let go of the inset. It is now firmly attached
to the drive shaft
4) Add the ingredients you wish to process to the
mixing bowl .
NOTE
► Please note that the dough in the mixing bowl
will increase in volume or will be pressed
upwards by the movement during the kneading
or mixing process. Therefore, never fill the
mixing bowl to the brim!
5) Push the release lever
the swivelling arm
with the mounted inset facing downwards.
6) Push the lid onto the mixing bowl
, whisk or beater
:
, whisk or
so that
fit into
.
firmly onto the drive
.
upwards and push
into its working position
.
GB
IE
7