Manual Lighting Procedure; Shutting Off Your Griddle - Pit Boss Ultimate Griddle Serie Handbuch

MANUAL LIGHTING PROCEDURE

1. Open lid during lighting.
2. Set all control knobs to the "O" position.
3. Open the cylinder/gas valve according to the operating
instructions on tank.
4. Quickly and carefully, use a lit match or long-nosed lighter to
light the burner. Gain access to the burner from beneath the
Hot Plate. Position lit match near the side of the burner.
CAUTION: Do not attempt to light another area of the
burner. This can cause injury.
5. Push and turn the burner control knob counter-clockwise to
" (light position)", hold this knob in for 10 seconds after the
burner is lit. You will hear the "snapping" sound of the spark
until after the knob is released.
NOTE: Do not use spirit, lighter-fluid or kerosene for lighting or refreshing a fire in your griddle.
6. If the burner does not light within 5 seconds, turn burner control knob to "O", wait 5 minutes, and repeat lighting instruction.
After lighting, observe the burner flame. Make sure all burner ports are lit and flame height matches illustration shown
previously.
NOTE: Each burner lights independently - repeat same steps for other burners.
WARNING: Never lean over the cooking area while lighting your gas griddle. Keep your face and body a safe
distance (at least 457 mm / 18 inches) from the cooking grid surface when lighting your griddle by match.
7. If the above points do not work, see Troubleshooting.

SHUTTING OFF YOUR GRIDDLE

1. When finished cooking, turn gas cylinder valve to the CLOSED position, and allow the regulator knob to pop out. This safety
feature locks the regulator knob to ensure that the gas is no longer flowing.
2. Turn control knobs to the "O" position.
NOTE: A "poof" sound is normal as the last of the LP gas is burned.
3. Disconnect gas supply by following the Disconnecting A Gas Cylinder instructions.
WARNING: Allow the griddle to cool completely, and remove the gas cylinder, before moving, travel, or for
storage.
11