Manual Lighting Procedure; Shutting Off Your Grill - Pit Boss PB2BPGG Handbuch

IGNITER FAILURE PROCEDURE
If for any reason your igniter fails after three of four attempts, check the following steps, or start your grill
using the manual method.
1. Ensure the control knobs are turned to the OFF position. Allow any accumulated gas to dissipate.
2. After five minutes, check the following:
• Visually confirm that the igniter is working by pushing the igniter button and looking at the igniter tip for a
spark. If no spark, adjust the distance between the igniter (electrode) tip and burner to 4.5 mm (3/16 in).
• Visually confirm that the burner tube and portholes are not obstructed. If blocked, follow Care & Maintenance
instructions .
3. If the above points do not work, follow Troubleshooting instructions .

MANUAL LIGHTING PROCEDURE

1. Verify that the control knob is turned to the OFF position.
2. Lift one of the Cooking Grids to expose the burners.
3. Connect LP gas cylinder as per instructions. Turn LP gas
cylinder valve to OPEN.
4. Note the indicator marker on the control knob. Push in
the regulator knob and turn 90 degrees (or 1/4) counter-
clockwise to HIGH.
5. Quickly and carefully, use a lit match secured with the
lighting rod (included with the grill) to light burners.
Access the burners through the cooking grids. Position lit
match near side of burner. Do not attempt to light another
area of the burner. This can cause injury.
NOTE: Do not use spirit, lighter-fluid or kerosene for
lighting or refreshing a fire in your grill.
6. After the burner has caught fire, place the Cooking Grid
back into position, and you are ready to enjoy your grill at
your desired temperature!

SHUTTING OFF YOUR GRILL

1. When finished cooking, turn LP gas cylinder valve to the CLOSED position, and allow the regulator knob to pop out. This
safety feature locks the regulator knob to ensure that the gas is no longer flowing.
2. Turn control knobs to the OFF position.
NOTE: A "poof" sound is normal as the last of the LP gas is burned.
3. Disconnect LP gas cylinder by following the Disconnect LP Gas Tank instructions.
WARNING: Allow the grill to cool completely, and remove the gas cylinder, before moving, travel, or for
storage.
8