Yamaha WR450F 2004 Fahrer- Und Wartungshandbuch Seite 164

1 Hot starter cable
2 Clutch cable
3 Throttle cable (return)
4 Throttle cable (pull)
5 Ignition coil
6 Negative battery lead
7 Starter motor lead
8 Coolant reservoir tank
breather hose
9 Rectifier/regulator
0 Cable holder
A Coolant reservoir hose
B Rectifier/regulator lead
C Clamp
D CDI unit lead
E CDI unit
F CDI unit band
G CDI unit stay (frame)
H Cable bracket
CABLE ROUTING DIAGRAM
Å Pass the throttle cables, clutch
cable and hot starter cable through
the cable guides.
ı Pass the throttle cables, clutch
cable and hot starter cable between
the radiator and frame, then over
the middle radiator mounting boss.
Ç Pass the throttle cables and clutch
cable on the outside of the ignition
coil.
Î Pass the carburetor breather hose
(throttle cable cover) through the
hose holder.
‰ Fasten the coolant reservoir tank
breather hose and
breather hoses together with a
plastic locking tie.
2 - 25
Ï Fasten the grommet of the clutch
cable with the cable holder.
Ì Fasten the rectifier/regulator lead to
the frame with a plastic locking tie
and cut off the tie end.
Ó Fasten the CDI unit lead to the
frame with a plastic locking tie ends
at the lower of the frame and cut off
the tie end.
È Insert the CDI unit band over the
CDI unit stay (frame) as far as pos-
sible.
Ô Fasten the starter motor lead and
negative battery lead to the cable
carburetor bracket in its slot with a plastic lock-
ing tie and cut off the tie end.
 Do not allow the rectifier/regulator
lead to slacken.
SPEC