Monosem EXTEND 6 rangs Bedienungsanleitung Seite 9

DANGER ZONES
▪ The area shown in the diagram indicates the danger zone of the machine.
SEED PLANTER WITH DANGER ZONE DIAGRAM
▪ Failure to respect the danger zone can result in serious injury or death.
▪ Keep people away from the danger zone.
▪ Only move the machine when no one is in the danger zone.
▪ Operate the machine's various equipment only if no one is in the danger zone.
▪ When working on the machine, even for short periods of time or for close visual inspections, secure the tractor and the machine.
▪ Do not park in the zone of action of the furrowers.
OVERHEAD LINES
▪ Observe the maximum possible height of the three-point linkage.
▪ When folding and unfolding, ensure sufficient distance from power lines.
▪ Never get on or off the machine under power lines to avoid the risk of electric shock due to voltage discharges.
▪ When working, make sure you keep a sufficient distance from power lines.
FERTILIZERS AND TREATED SEEDS
▪ Only use fertilisers and seeds that meet the requirements.
▪ Avoid all contact, direct or by inhalation, with the products. Observe the instructions of the manufacturer of the supplies.
▪ Revise the use of damp fertilizer or seed to avoid blockage in the box or hopper.
▪ It is always recommended to mix talcum powder with the seeds to reduce friction between seeds.
MAINTENANCE AND REPAIR INSTRUCTIONS
▪ Make sure to switch off the engine, remove the ignition key and wait for all moving parts to come to a complete stop before leaving the tractor or performing any
operation on the machine.
▪ The PTO must be disengaged, the engine switched off and the ignition key removed before carrying out any maintenance, servicing, or repair work on the machine.
▪ Screws and nuts must be tightened regularly. After the first hours of use (4 hours), all screws must be retightened. Repeat the operation every 80 hours.
▪ Before carrying out any maintenance work on a raised machine, first support it.
▪ Do not work under the machine without securing it.
▪ Do not use the lifting eye to lift the machine when it is loaded.
▪ Wear gloves and use only the correct tools when replacing a working part.
▪ It is prohibited to throw away oil, grease, or filters in consideration of the environment.
▪ The power source must be disconnected before any work is carried out on the electrical circuit.
▪ Parts subject to wear and tear should be checked regularly and replaced if worn or damaged.
▪ The use of MONOSEM spare parts is mandatory, as these correspond to the characteristics defined by the manufacturer.
▪ The alternator and battery cables must be disconnected before any electrical welding work is carried out on the tractor or coupled machine.
▪ Only qualified personnel may carry out repairs involving parts under voltage or pressure.
ENVIRONMENTAL PROTECTION
▪ Consumables such as hydraulic oil, lubricants, etc. can harm the environment and people's health.
▪ Make sure that used grease and substances such as oils, fats, or product residues after use are not spilled on the ground and are not disposed of in the sewer system.
▪ Absorb spilled consumables with absorbent material or sand, collect them in a leak-proof container and dispose them in accordance with legal requirements.
▪ Observe the instructions of the manufacturer of the consumables.
▪ Intervene when the weather conditions are favourable for the maximum efficiency of the phytosanitary product used, limiting the impact of this product on the
environment as much as possible.
SPARE PARTS
▪ The use of MONOSEM spare parts is mandatory, as these correspond to the characteristics defined by the manufacturer.
The installation or use of parts that are not original MONOSEM parts may, in some cases, endanger the safety of people and the machine.
▪ The company Ribouleau MONOSEM cannot be held liable for damage due to the use of non-original parts and accessories.
▪ If in doubt about the assembly of equipment and spare parts, contact your dealer or the MONOSEM customer service department.
MODIFICATIONS TO THE MACHINE
▪ Construction modifications that are not authorised by MONOSEM may affect the correct operation and safety of the machine.
▪ The user or owner is responsible for any modifications to the machine that are not approved by MONOSEM.
▪ MONOSEM cannot be held liable for damage to persons or damage to property resulting from unauthorised modifications.
9