Start / Stop Heater; Set / Edit Parameters; Set Or Display; Select Value - Heidolph Synthesis 1 Betriebsanleitung

E
9.3

Start / Stop heater

Heater is turned ON / OFF with Start Stop Heater key. In ON mode,
a green LED turns on.
9.4

Set / edit parameters

Value / Speed rotary knob sets / edits parameters. "act "
displayed, shaking frequency is changed; set displayed, edits a
parameter marked with an arrow key. Rotate knob clockwise to
increase, counter clockwise to decrease.
Values so set are saved automatically.
9.5

Set or display

Act / Set key is used to select between display mode and set mode. Display
mode is marked act in display, set mode displays set (set value)
9.6

Select value

A value to be edited in "Set" mode is marked by cursor. Cursor is
moved with two Select keys.
In "Set" mode, cursor is moved with Select
Timer-Speed etc.;
and vice versa with Select
In "Set Ramp" mode, cursor is moved with Select
key from No to zone – Temp Step 1 - Time Step 2 –
Temp Step 2 etc.,
and in opposite direction with Select
9.7

Set temperature gradient

Set Ramp key is used to set one or more temperature gradients
9.8

Activate temperature gradients

Ramp Active key activates a certain temperature gradient.
9.9

Identic

Identic key harmonizes 4 ea. temperature zones (all four are set to same
temperature), such value being transmitted from zone 1 to the other zones.
When programming temperature gradients, Identic key sets temperature
gradient of all of the 4 heater zones.
key from zone 1 to zone 2-3-4-
key.
. key.
90
Cursor