INVENTOR V5MFI-66 Benutzer- & Installationshandbuch Seite 13

4
ADJUST
button：
Temperature adjust: Press the "
1.
16°C/17 °C~30 °C or 20°C~28°C .
2. Timer adjust: Adjust the timer on/off time under the Timer setting mode(0~24hs).
Auxiliary function
3.
4. Under test run operation, press "
T3(some units) and T4(some units) , the protection or error codes. The sensor malfunction can
also be detected.
5 AUXILIARY FUNCTION(FUNC) button: Use this button to select or cancel the auxiliary feature.
When the unit is on, press this button, then press the ADJUST "
desired feature. Each time the button is pressed, the mode is shifted in the direction of the arrow:
When press the "
When press the "
Once the desired feature is established, press the AUXILIARTY FUNCTION button again to register .
If the button of AUXILIARY FUNCTION(FUNC), " " or "
or the other button is pressed, or any remote operation is performed, the auxiliary function setting
feature is automatically cancelled.
When the unit is off , only the TIMER ON and TIMER OFF feature can be selected.
NOTE : If the feature selected is not supported by the machine you purchased, the mode is
shifted to the next feature automatically in the direction of the arrow as shown above.
Test Run button：
6
This button is specially designed for maintenance technicians.
Press this button to start test running operation, press it again to stop the operation (For Model
B/C/D).
Press and hold FAN and FUNC. buttons together for one second to start/stop test running
operation(For Model A).
The test running operation will last 30 minutes regardless of the setting temperature.
" and "
selection: Select the desired auxiliary function by pressing"
" and "
" button:
" button:
" to adjust the temperature in a range of
" buttons can display the temperature of T1, T2,
" or "
" is not pressed during a 10 seconds period,
" and" " button.
" button to select the
 Page 13 