Operation Buttons - INVENTOR V5MFI-66 Benutzer- & Installationshandbuch

NOTE: If the unit is turned off under COOL, AUTO or DRY mode with the set temperature less than 24 °C,
the set temperature will be automatically set to 24
off under HEAT mode with the set temperature more than 24 °C, the set temperature will be automatically
set to 24 °C when you turn on the unit again (Applicable to some products only).

Operation buttons

The display panel on the indoor unit can be used to operate the unit in cases when the remote
control has been misplaced or is out of batteries.
1
ON/OFF button : Operation starts when this button is pressed and stops when you press the
button again.
MODE button: Press this button to select the appropriate operating mode. Each time the button
2
is pressed, the operation mode is shifted in the direction of the arrow:
AUTO COOL
Auto: Automatically chooses the operation mode by sensing the difference between the actual
ambient room temperature and the set temperature on the remote controller. The fan speed is
automatically controlled.
Cool: Enables you to enjoy the cooling effect at you preferred setting temperature .
Dry: Permits dehumidifying operation . In Dry mode, you can not select Fan speed.
Heat: Permits heating operation (For cooling & heating models only).
Fan only: Permits fan operation without cooling or heating. In this case, however, the setting
temperature is not displayed and you cannot adjust the set temperature.
Auto operation display
Cooling operation display
Dry operation display
Heating operation display
Fan operation display
Lock operation display
Swing operation display
Sleep operation display
Turbo operation display
On timer operation display
Off timer operation display
Fan speed display
°C
DRY HEAT(for cooling & heating units only)
when you turn on the unit again. If the unit is turned
FAN ONLY
 Page 11 