3M DBI-SALA Nano-Lok XL Bedienungsanleitung Seite 11

6.0 MAINTENANCE, SERVICE, and STORAGE
6.1 CLEANING: Cleaning procedures for the SRD are as follows:
• Periodically clean the exterior of the SRD using water and a mild soap solution. Position the SRD so excess water can
drain out. Clean labels as required.
• Clean the Lifeline with water and mild soap solution. Rinse and thoroughly air dry. Do not force dry with heat. The
lifeline should be dry before allowing it to retract into the housing. An excessive buildup of dirt, paint, etc. may
prevent the lifeline from fully retracting back into the housing causing a potential free fall hazard.
6.2 SERVICE: SRDs are not repairable. If the SRD has been subjected to fall force or inspection reveals an unsafe or
defective condition, remove the SRD from service and discard (see "Disposal").
6.3 STORAGE/TRANSPORT: Store and transport SRDs in a cool, dry, clean environment out of direct sunlight. Avoid areas
where chemical vapors may exist. Thoroughly inspect the SRD after any period of extended storage.
6.4 DISPOSAL: Dispose of the SRD if it has been subjected to fall arrest forces or inspection reveals an unsafe or defective
condition. Before disposing of the SRD, cut the lifeline in half or otherwise disable the SRD to eliminate the possibility of
inadvertent reuse.
;
Remove all attached RFID Tags before disposing of this product. RFID Tags must be disposed of according to the
restrictions specified in Section 7.
7.0 RFID Tag
7.1 LOCATION: 3M product covered in these user instructions is equipped with a Radio Frequency Identification (RFID) Tag.
RFID Tags may be used in coordination with an RFID Tag Scanner for recording product inspection results. See Figure 9
for where your RFID Tag is located.
7.2 DISPOSAL: Prior to disposing of this product, remove the RFID Tag and dispose/recycle in accordance with local
regulations. For additional information on how to remove the RFID Tag, please refer to the website link below.
Do not dispose of your product as unsorted municipal waste. The crossed-out wheelie bin symbol indicates that
all EEE (Electrical and Electronic Equipment) must be disposed of according to local law through available return
and collection systems. Please contact your dealer or your local 3M representative for further information.
For more information, please visit our website: http://www.3M.com/FallProtection/RFID
8.0 Labels
Figure 14 illustrates the labels of the Self-Retracting Devices and their locations. All labels must be present on the SRD. If any
labels are missing or not fully legible then they must be replaced. Information present on each label is as follows:
ID Label
A
1) Inspect the device before use. 2) Inspect locking of the SRD before use.
B
3) Ensure proper connection to your Full Body Harness.
4) For overhead use only. 140 kg (310 lbs) maximum.
5) Service Temperature Range: -40°C to 60°C (-40°F to 140°F)
6) Maximum Capacity: 1 user, 140 kg (310 lbs) combined weight (includes tools, clothing, etc.)
7) Always allow the lifeline to recoil back into the SRD housing under control.
8) Do not attempt to repair, modify, or disassemble this device.
9) Store and transport SRDs in a cool, dry, clean environment out of direct sunlight.
10) Do not use this device over sharp edges or abrasive surfaces. See Section 1.4.
11) Do not run the lifeline over sharp edges or abrasive surfaces. See Section 1.4.
12) Do not remove labels.
11