Recommended Fire-Extinguishing Devices; Glossary - ATH-Heinl ATH LUX 3D Bedienungsanleitung

RECOMMENDED
FIRE-EXTINGUISHING
DEVICES
When choosing the most suitable fire
extinguisher refer to the table below.
Dry materials
Water
Foam
Powder
CO
2
YES* Use only if more appropriate
extinguishers are not on hand or
when the fire is small.
Flammable liquids
Water
Foam
Powder
CO
2
Electrical equipment
Water
Foam
Powder
CO
2
WARNING
The information in this table is of a gen-
eral nature and is intended to provide
users with general guidance. Contact
the manufacturer for details of the ap-
plications of each type of extinguisher.
YES
YES
YES*
YES*
NO
YES
YES
YES
NO
NO
YES
YES
Below is a brief description of some
‑ technical terms used in this manual.
Characteristic Angles
This term refers to all the angles that
can be normally measured with a wheel
aligner (total front/rear toe, left/right
and front/rear half toe values, left/right
and front/rear camber, left/right caster,
left/right king pin angle, and steering
angle difference at 20°).
CCD
Special type of infrared sensor with
perfect linearity.
Clamps
Adapter between wheel and the measure-
ment target.
Equatorial plane
Hypothetical vertical plane that divides
the wheels into two equal parts.
Turntable
This is a base mounting a disk on which the
steer wheels of the vehicle are positioned.
Turntables reduce friction between the
tyre and the ground to facilitate settling
in of the suspensions and to cancel
measurement errors during steering
turns. The area between the disk and
the base must be always clean.
Infrared beams (I.R.)
Electromagnetic waves that are invisible
to the naked eye.
Transducer
Electronic component that converts a
physical parameter into another type of
parameter; e.g. angle transducers con-
vert angles into proportional electronic
signals.

GLOSSARY