Main Screen; Operating Sequence Screen - ATH-Heinl ATH LUX 3D Bedienungsanleitung

MAIN SCREEN

The following keys are active in the main
screen (fig.24):
F1 displays the on-line Help func-
tion
Exit the alignment program
F2
and goes back to the Win-
dows desktop (with password
prompt)
(or Enter) goes to the next
F3
screen in the established
operation sequence (vehicle
databank, job record, com-
pensation).
F11
Displays the menu with the
contextual functions.
These are the menu options:
• Switch off (Exits the program and Windows
correctly)
• Skip operation (skips the job record filing
or databank selection and gets directly to
the ROC execution screen)
• Utility programs
- Technical assistance
- Smart card data card (displays the
main USB key enabled options and
those that can be enabled using the
update USB key)
- Technical assistance (screen to be
used by the technical personnel)
- Target test (displays the targets opera-
tion analysis screen)
- Demo (uses the program in demo mode,
without using the targets)
• Previous job (recalls the last job per-
formed, Make, Model, ROC and data).
• Setup (accesses the aligner general set-up)
• Operating sequence (recalls the align-
ment execution setting screen, according
to the user's preferences)
• Help (recalls the contextual Help screen
on the screen where you are)
The general set-up and the operating
sequence screen have been introduced
because some users prefer to change all the
available options and define the equipment
settings before resuming measurement.
OPERATING SEQUENCE
SCREEN
The operating sequence to be used for the
next alignment procedure can be selected
in this screen (fig.26).When the alignment
procedure finishes, or every time the op-
erating sequence begins (from the starting
screen), the settings of the general set-up
are reset.
The operating sequence settings can be
accessed, from any job screen, during the
alignment procedure.
In the operating sequence, the operations
are divided in subgroups, where the desired
setting can be selected for each group.
Find below the groups and their possible
options:
Select vehicle
Select ROC
Databank
Job record
Skip vehicle
selection
Recall ROC
Push mode ROC