Switching The Aligner On And Off - ATH-Heinl ATH LUX 3D Bedienungsanleitung

RG3) LINK LED for the rear right target
RG4) LINK LED for the rear left target
Operation:
GREEN LED ON = THE TARGET ACQUISI-
TION IS OK. THE TARGET IS LOCKED.
RED LED ON = THE TARGET ACQUISITION
IS NOT OK. THE TARGET IS NOT LOCKED.
ANY PROBLEMS ON TARGET.
DIRECTION
(illuminated in blue):
These LEDs indicate the operations to be
carried out by the operator during
operation of steering and ROC.
B1) LED indicator "forward", used in the
procedure of the ROC. When lit, it
indicates forward to push the vehicle.
B2) LED indicator "right", used in the
steering procedure.
indicates to steer to the left.
B3) LED indicator "back", used in the
procedure of the ROC. When lit, it
indicates to push back the vehicle.
B4) LED indicator "left", used in the
steering procedure.
indicates to steer to the left.
Notes:
The STOP condition for storage of data
is signaled by
activation of all 4 blue LEDs. This
condition happens during the phases of
steering and ROC, during the storage of
data.
In standby mode, all the LEDs of the
cards flash alternatively.
INDICATORS
When lit,
When lit,
the simultaneous
SWITCHING THE ALIGNER
Turn on the aligner by setting the switch
(A, fig. 6) to "I" (On).
Then wait until the starting screen is
displayed (fig. 24).
To switch the aligner off correctly,
LED
proceed as follows:
• go back to the starting screen (fig. 24);
• Access the menu by pressing F11
• Select the "turn off" option
• Confirm the switching off by pressing
F3
CAUTION
Never switch off the machine when
there is a page other than the logo page
it
displayed because such an action might
damage the PC.
Should this occur, when the PC is switched
on again, the software will request the
user to press any key to perform the
"SCANDISK" operation.
it
This operation is used to check that the
PC has not been damaged and, if
necessary, to update some files that might
have been damaged.
At the end of the process, if the program
reboots normally, then no problems have
occurred. Instead, if any message appears
blocking the program start-up procedure,
contact the nearest technical assistance
center.
ON AND OFF
Central unit